|
Valve
Cover Evacuation Kit
 Remove Stock
Breather
and section of 3/8 metal tube
that attatches to
turbo compressor
elbow. Thread
the supplied pipe
plug into fitting on compressor housing, or directly into compressor
housing.
 Note:
The pipe plug
supplied may very. If it looks like the one
in the picture to the right, fit it directly into the compressor
housing
elbow. If it has a recess in the top portion of the plug, it goes into
the same
port you will be removing the 3/8s metal hose from. They are different
thread
sizes, so it will be self evident. All kits built as of June
01 2004 will
use the plug that goes
into the stock fitting so
as to retain the vacuum port.
Insert
supplied elbow into valve cover. A little oil on the
o-ring will help it slip into place if you have problems sliding it
into the
valve cover hole. Place external breather in a location that best suits
your
vehicle. In our example vehicle it is on the inner fender by the cold
air intake hose. (right
photo - highlighted)
Cut
hose to length, and use the supplied hanger and sheet
metal screw to mount and secure the hose, keeping it away from engine
heat
sources.
|
